Holster Claw (Concealment Wing) Installation Guide

This guide walks you through installing the Lindahl Holsters® concealment wing (claw) exactly as shown in our video tutorial.

What’s Included in the Kit

• 1× Concealment Wing
• 2× Pressure Wing Inserts (two sizes)
• 2× Screws
• 2× Locking Posts
• 1× Nut
• 1× Flathead Screw

Step-by-Step Installation

1. Remove holster from package.
2. Remove the concealment wing kit.
   Confirm your kit includes the wing, two pressure pieces, two screws, one nut, one flathead screw, and two locking posts.
3. Remove retention screws.
   Take out the existing retention screws from the holster.
4. Place locking posts through the retention holes.
   Install the locking posts above the retention washers and between the holster shells. Ensure both posts seat cleanly.
5. Place the wing on top of the locking posts.
   Position the concealment wing over the posts you just installed.
6. Secure the wing to the holster.
   Use the included screws to fasten the wing—each screw must pass through the locking posts. Before fully tightening, align the wing horizontally with the bottom of the trigger guard, then tighten both screws until the wing locks in place.
7. Reset and adjust retention.
   Squeeze the holster shells together and use the screws to pop the retention posts back through on the back side of the holster. Then use a flat-blade screwdriver to fine-tune retention.
8. Install the pressure wing piece.
   Choose one of the two pressure piece sizes. Press it onto the top of the concealment wing—the two slots will lock it in place. Turn the holster over and install the nut. Hold it in place, flip the holster back, insert the included flathead screw, and secure the pressure piece.

Your holster is now complete and ready to wear.

Video Tutorial

Watch the full installation walkthrough:

Tips for Best Results

• Use a drop of medium-strength threadlocker (blue) on screws if you prefer a long-term set.
• Re-check screw tightness periodically with daily carry.
• Adjust ride height and cant after install for best concealment and comfort.

Need Help?

Questions about installation? Email support here